In order to ensure that machine use stability, Avoid electrostatic the effects on the machine.
Must install earth for machine and make sure earth well.
2.3.1 Build earth
Ø With 2.5 m copper wire inserted 1.5 ~ 2 m deep underground, irrigate salt water.
Ø Using copper metal contact pipe and the pipe have fresh water
Ø Joint Angle of 40 cm in 50 kg of salt water bucket.
Note: Please use humidifier at dry indoor.
2.3.2 Connect earth
Figure 18.104.22.168 figure on the left (machine) on the back shows the left leg and left foot separation diagram, which is marked with blue line where the screw joint .Figure on the right side (positive) machine shows the left leg and left foot connection good rendering, including the foot bolt hole direction of the arrow mark on the outside of the machine (namely the left foot to the left, right foot on the right), the right side of the support legs, the right foot with the left side of the installation.
2.1.2 Install the tension rod
Figure 22.214.171.124 (machine) on the back shows the tension rod installation, and has been installed around the supporting leg and foot.The tension rod fixed screw, each side has four 2 connect the front of the support leg, the other 2 connect the supporting leg medial side.
Figure 126.96.36.199 (machine) on the back shows the tension rod connected to the leg of a good effect.
2.1.3 Fixed plate installation support legs
Arrow in figure 188.8.131.52 (positive) machine is the supporting leg fixed plate, the installation location in positive machine, support the joint of the bottom of the legs and feet.
Figure 184.108.40.206 (positive) machine shows supporting leg fixed plate installation after the completion of the rendering.
2.1.4 Fixed plate and reinforcement part
Figure 220.127.116.11 With the arrow mark to put paper fixed plate, the arrow mark for reinforcement.
Figure 18.104.22.168 shows the paper fixed plate and the effect of reinforcement installation is completed.
Figure 22.214.171.124 orange round the location of the installation.